REMOVING THE DRIVE BELT AND MOTOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Use cardboard or padding to lay washer
4. Disconnect hoses.
5. Remove pulley cover.
6. To remove the belt, pull out on the belt
7. To remove the motor, unplug the
Mounting Bolt
Belt
Mounting Bolt
Figure 1
4-13
on the front cabinet.
and turn the splutch pulley until the belt
slides off.
harness and remove the two (2)
mounting bolts, see figure 1.
Splutch Pulley