Key Activation & Encoder Test; Service Test Mode - Whirlpool W10607408B Manual

FOR SERVICE TECHNICIAN'S USE ONLY
1st Button
2nd Button
3rd Button
• See "Activating Service Diagnostic Mode" to activate these buttons. Make sure all of step 3 is complete before activation.
Activation with Saved Fault Codes
If there is a saved fault code, it will be flashing
in the display. Review the Fault/Error Codes
table on pages 8–10 for the recommended
procedure. If there is no saved fault code,
"888" will be displayed.
KEY ACTIVATION & ENCODER TEST
NOTE: The Service Diagnostic mode must be
activated before entering the Key Activation &
Encoder Test; see procedure on page 2.
Entry Procedure
Press and release the 1st button used
to activate Service Diagnostic mode.
The following test will be available:
DIAGNOSTIC: Key Activation & Encoder Test
Pressing each button will turn off its
corresponding indicator(s) or display segment
and sound a beep.
Rotating the cycle selector knob (on some
models) turns off each corresponding cycle
indicator and sounds a beep.
NOTE: A second press of the POWER button
while in Key Activation & Encoder Test or
pressing and holding the 1st button used
to enter Service Diagnostic mode exits the
Service Diagnostic mode and returns the
washer to standby mode.

SERVICE TEST MODE

NOTE: The Service Diagnostic mode must be
activated before entering Service Test Mode;
see procedure on page 2.
NOTE: If, at any point, the user presses the
POWER button during Service Test Mode, the
washer exits to standby mode.
DO NOT REMOVE OR
SERVICE DIAGNOSTIC MENU TABLE
Button Press
- Momentary press
- Press and hold for 5 secs.
- Momentary press
- Press and hold for 5 secs.
- Momentary press
- Press and hold for 5 secs.
DESTROY
Function Behavior
- Activates Key Activation
& Encoder Test
- Exits Service Diagnostics
- Activates Service Test Mode
- Software Version Display
- Displays Next Error Code
- Clears the Error Codes
Active Fault Code Display
in Service Test Mode
If the display begins flashing while in Service
Test Mode, it is displaying an active fault code.
Active fault codes are codes that are currently
detected. Only one active fault code can be
displayed at a time.
Entry Procedure
To enter Service Test Mode, press and release
the 2nd button used to activate the Service
Diagnostic mode.
Successful Entry
All LEDs turn off except the POWER button
indicator and the START button indicator
begins to flash.
Service Test Load Control
and Service Cycle Modes
Test Load Selection Procedure
To select Load or Service Diagnostics, use the
Soil Level and Temp buttons or cycle selection
knob, if available. Soil Level will increment
through the loads and Temp will decrement
through the available functions.
Rotating the cycle selection knob clockwise
will increment the selected function while
rotating counterclockwise will decrement
through the available functions.
Load Control Status Indication
The Estimated Time Remaining (ETR) display
will indicate the current selected load or
function. If the selected load is currently active
(commanded on), the ETR display will flash
the load number at a 1Hz rate. If the load is
currently commanded off, the ETR display
will show the load number without flashing.
PAGE 3