Removing The Control - Whirlpool MVWC400XW Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the control panel. See the
section: "REMOVING THE CONTROL
PANEL".
4. Remove harness from control, see figure 1.
a. Pull tabs back for J-2 removal.
b. Pull tabs back for J-12 removal.
c. Remove two wire connector at J-7.
d. Wires for J-3 are routed and tucked
under the braces and are held in
place by a tree clip. Remove the
connector by pinching the tabs on
the sides of the connector.
e. J-15 and J-16 are "pinch"
connectors and the wires are held
by a tree clip.
J-7 J-16
Figure 1

REMOVING THE CONTROL

J-2
J-12
J-15 J-3
5. Remove the knob by grasping it and
pulling it toward you, see figure 2.
6. Remove one (1) screw and release two
(2) locking tabs on the User Interface to
replace control, see figure 3.
Tab Capture
Screw
4-4
Figure 2
Locking Tabs
Figure 3