Manual Overview Test Mode - Whirlpool Maytag MVWP576KW Technical Manual

3.5 cu. ft. commercial-grade residential agitator washer

Table of Contents

Pressing the START button will activate/deactivate each output. When the output is activated, the corresponding Status LEDs will flash. See page

access Manual Overview Test Mode.

IMPORTANT: Lid must be closed and locked to perform SPIN and AGITATE tests.

OUTPUT

Output Details

NOTE: Outputs will time-out after 5 minutes.

LID LOCK

Lock and unlock the lid.

NOTES:

n When lock is enabled, the "Lid Locked" LED will turn ON. Will only lock when lid is closed. Will only unlock when basket RPM is 0. If lid is not

closed, washer will flash status LEDs on and off.

n If lid does not lock or unlock, go to

COLD VALVE

Turns ON and turns OFF cold water valve.

n If valve does not turn on, go to

HOT VALVE

Turns ON and turns OFF hot water valve.

n If valve does not turn on, go to

UNUSED

DRAIN

Turns ON and turns OFF the drain pump.

n If pump does not turn on, go to

UNUSED

LOW SPIN – To perform test, lid must be closed and locked.

Spins basket from 0 to 500 RPM.

NOTE: Allow up to 15 seconds f or shifter to reposition.

IMPORTANT: To activate Low Spin, RPM must read "0" and lid must be closed with lid lock enabled.

If lid is not closed, status LEDs will flash on and off.

IMPORTANT: Water in tub must be drained before test.

n If motor does not spin, go to

HIGH SPIN – To perform test, lid must be closed and locked.

Spins basket from 0 to maximum RPM.

NOTE: Allow up to 15 seconds for shifter to reposition.

IMPORTANT: To activate High Spin, RPM must read "0" and lid must be closed with lid lock enabled.

If lid is not closed, status LEDs will flash on and off.

IMPORTANT: Water in tub must be drained before test.

n If motor does not spin, go to

For Service Technician Use Only