Troubleshooting - Whirlpool MVWC400XW Technical Education

First try the solutions suggested here or visit our website at www.whirlpool.com/help
If you experience
Vibration or Off-Balance
Check the following for
proper installation or
see "Getting Started"
section.
Noises
Clicking or metallic
noises
Gurgling or humming
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Not enough water
in washer

TROUBLESHOOTING

for assistance and to possibly avoid a service call.
Possible Causes
Feet may not be in contact with the
Washer may not be level.
Load could be unbalanced.
Objects caught in washer
drain system.
Washer may be
draining water.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers
Drain hose connection
Check household plumbing for leaks
or clogged sink or drain
Washer not loaded properly.
Load not completely covered
in water.
must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in Installation Instructions.
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
basket. Avoid washing single items.
Use Bulky Item cycle for oversized, non-absorbent items such as
See "Cycle Guide" and "Using Your Washer" in this Use and
Care Guide.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming sound
removed during the spin/drain cycles.
Water may splash off basket if washer is not level.
Check that load is not unbalanced or overloaded.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can backup out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets.)
Improper loading can cause basket to be out of alignment
and cause water to splash off tub. See "Getting Started"
for loading instructions.
This is normal operation for an HE low-water washer. The load will
not be completely underwater. The washer senses load sizes and
adds correct amount of water for optimal cleaning. See "What's
New under the Lid."
IMPORTANT: Do not add more water to washer. The added water
lifts the load off the impeller, resulting in less cleaning.
3-14
Solution