Removing The Control Panel - Whirlpool MVWC400XW Technical Education

REMOVING THE CONTROL PANEL

Access to the water inlet valves, control and
user interface is from inside of the control
panel.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove only the (2) top screws from the
control panel's rear panel, see figure 1.
Remove these Screws
Figure 1
4. Push back on the control panel just
enough to slide a putty knife under the
right or left corner of the control panel.
Lift the corner of the panel and push in
with the putty knife blade to release the
clip. Repeat the procedure for the other
clip, see figures 2 and 3.
5. Lift the panel off of the top, see figure 4.
4-3
Clip Locations
Figure 2
Figure 3
Clip
Figure 4