Table of Contents
Advertisement
REMOVING THE THERMAL FUSE, OPERATING
THERMOSTAT, DRIVE MOTOR, & BROKEN BELT SWITCH
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug dryer(s) or disconnect power.
2.
Turn off gas supply to dryer(s).
3.
Open the dryer door and remove the lint
filter screen, then close the door.
Lint Filter Screen
4.
Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
5.
Remove the hex-head screw from the lint
duct bracket and remove the bracket.
6.
Remove the two hex-head screws from
the lint duct and remove the duct.
Lint Duct Bracket & Screw
7.
To remove the thermal fuse or operating
thermostat:
a) Remove the two wires from the termi-
nals.
b) Remove the two hex-head screws.
2 Cover Screws
Continued on the next page.
4-45
Lint Duct Screws
Thermal Fuse
(2 Screws)
Operating
Thermostat
(2 Screws)
Blower Cover
Advertisement
Table of Contents
