Without Using A Flash Memory Card - Ricoh B039 Service Manual

USING SERVICE PROGRAM MODES

Without Using a Flash Memory Card

If there is no flash memory card, follow the steps below.
1. Print out all SMC data lists (SP5-992).
NOTE: For B039 models outside N. America, these lists cannot be printed
without the IMB installed. Therefore, if it is not installed, write down all
the data stored in NVRAM (all user tool settings, and all SP settings
except for those listed above).
2. Access SP mode 5-801.
3. Press the Original Type key and the OK key (or ') key at the same time. If the
operation is successful, the display shows "Action completed". If the clear fails,
the display shows "Error!!!".
4. Turn the main switch off and back on.
5. Do the printer and scanner registration and magnification adjustments
(☛ Replacement and Adjustment – Copy Adjustments).
6. Refer to the SMC lists or the data you have written down, and re-enter any
values that differ from the factory settings. In particular, the values for SP4-904,
SP4-905, SP4-906, and SP4-907 must be re-entered.
7. Do the standard white level adjustment (SP4-908).
8. Check the copy quality and the paper path, and do any necessary adjustments.
B039/B040/B043 5-40 SM