Ricoh B039 Service Manual page 442

Scanner Switch 0D
No FUNCTION
0 Scan magnification ratio fine tuning (Main scan direction)
1    
0 1
  =     =   −
0 %, 1
   
0 0
The actual magnification ratio is the sum of the SP mode setting of copier and this
setting.
2 Scan magnification ratio fine tuning (Sub scan direction)
3    
0 1
  =     =  
−
0 %, 1
   
0 0
The actual magnification ratio is the sum of the SP mode setting of copier and this
setting.
4-6 Not used
7 Scan width for A5 SEF or B5
SEF originals
0: 210 mm (8.5")
1: Original width
Scanner Switch 0E
No FUNCTION
Wait time for the next page
0
when scanning a book original
into memory
0: 60 s
1: 30 s
1 Scan resolution unit
(except standard resolution in
book scan mode)
0: mm
1: inches
2 ADF jam alarm display time
0: 60 s
1: 30 s
3-7 Not used
SM
   
0 1
  =   +   =  
5 . %, 1 5 . %, Do
   
1 1
   
0 1
  =     =  
+
5 . %, 1 5 . %, Do
   
1 1
Do not change the settings.
0: The machine scans the original as 210 mm (8.5")
width. The transmitted image has a blank area on
the right.
1: The machine scans 148 mm (A5) or 182 mm (B5)
and centers the scanned data on a 216 mm width
transmitted image.
This bit determines how long the machine waits for
the next page when scanning a book original for
memory transmission. If this timer expires, the
machine transmits all the pages scanned so far as
one document.
Note: For immediate tx or parallel memory tx, the
wait time for the next page is 10 s.
This bit determines which resolution unit will be
used for scanning a fax message.
Default setting: mm
The bit is only effective when bit 0 of scanner bit
switch 0C is '0'.
This bit determines how long the machine displays
the ADF jam alarm after a jam occurred.
Do not change the settings.
5-25
COMMENTS
not use this setting
not use this setting
COMMENTS
BIT SWITCHES
B404