Memory All Clear (Sp5-801); Using A Flash Memory Card - Ricoh B039 Service Manual

5.1.8 MEMORY ALL CLEAR (SP5-801)

NOTE: Memory All Clear mode resets all the settings and counters stored in the
NVRAM to the defaults, except for the following:
• Electrical total counter values (SP7-003)
• Machine serial number (SP5-811)
• Plug & Play brand name and production name setting (SP5-907)
• Some SBU settings (SP4-904-6, SP4-904-7, SP4-905-6, SP4-905-7,
SP4-906-3, SP4-907-3)
• Language UK/TW Priority (SP5-916) – Asia and Taiwan versions only
Normally, this procedure should not be used. It is necessary only after replacing
the NVRAM, or when the copier malfunctions because the NVRAM is damaged.

Using a Flash Memory Card

1. Upload the NVRAM data to a flash memory card (☛ 5.1.10 NVRAM Data
Upload).
2. Print out all SMC data lists (SP5-992).
NOTE: 1) For B039 models outside N. America, these lists cannot be printed
without the IMB installed. Therefore, if it is not installed, write down
all the data stored in NVRAM (all user tool settings, and all SP
settings except for those listed above).
2) Be sure to print out all the lists. If the NVRAM data upload was not
completed, it is necessary to change the SP mode settings by hand.
3. Access SP mode 5-801.
4. Press the Original Type key and the OK key (or ') key at the same time. If the
operation is successful, the display shows "Action completed." If the clear fails,
the display shows "Error!!!".
5. Turn the main switch off and back on.
6. Download the NVRAM data from a flash memory card (☛ 5.1.10 NVRAM Data
Download).
SM
USING SERVICE PROGRAM MODES
5-39 B039/B040/B043