Without Using A Flash Memory Card; Replacement And Adjustment - Ricoh Russian-C2a Service Manual

10 August, 2001
5. Press Execute and turn the main switch off and back on.
6. Download the NVRAM data from a flash memory card (☛ NVRAM Data
Download).

Without Using a Flash Memory Card

If there is no flash memory card, follow the steps below.
1. Execute SP5-990 to print out all SMC Data Lists.
2. Open SP mode 5-801.
3. Press the number for the item that you want to initialize.
4. Press Execute and turn the main switch off and back on.
5. Make sure that you do the following:
• Do the printer and scanner registration and magnification adjustments (☛ 3
Replacement and Adjustment, "Copy Adjustments").
• Do the touch screen calibration (☛ 3 Replacement and Adjustment, "touch
screen calibration").
• Referring to the SMC data lists, re-enter any values, which had been
changed from their factory settings.
• Do SP 3-001-2 (ID Sensor Initial Setting) and SP4-911-1 (HDD media
check).
• Do the white level adjustment (☛ Section 6.8.2 Standard White Density
Adjustment)
6. Check the copy quality and the paper path, and do any necessary adjustments.
SERVICE PROGRAM MODE
4-65