Network Board Assembly Removal
Remove the network board, cable, and bracket assembly from the system board
as follows.
1. Remove the support plate from the system board (see "Support Plate
Removal" earlier in this section).
2. Position the system board with the processor side of the board facing up.
3. Unplug the network board cable from its connector on the LAN connector
board (see the following figure).
4. Remove the network board retaining screw from the system board as
follows.
!
Turn the system board over.
!
Remove the network board screw.
!
Turn the system board back over, with the network board side facing up.
A – System Board
B – Network Board
C – Network Board Screw
5. Unplug the network board from the system board and remove the network
board, bracket, and cable assembly from the system board.
6. As necessary, remove the bracket and cable from the board.
3-14 Disassembly and Reassembly
Removing the Network Board
D – Network Board Cable Connector
E – LAN Connector Board