Network Board Assembly Removal; Removing The Network Board - NEC PowerMate 2000 Series Service And Reference Manual

Network Board Assembly Removal

Remove the network board, cable, and bracket assembly from the system board
as follows.
1. Remove the support plate from the system board (see "Support Plate
Removal" earlier in this section).
2. Position the system board with the network board facing up.
3. Unplug the network board cable from its connector (
connector board (see the following figure).
4. Remove the network board retaining screw (
follows.
!
Turn the system board over.
!
Remove the network board screw (
!
Turn the system board back over, with the network board side facing up.
A – Screw
B – Network Board
C – System Board
5. Unplug the network board from the system board and remove the network
board, bracket, and cable assembly from the system board.
6. As necessary, remove the bracket and cable from the board.

Removing the Network Board

D – Network Board Cable Connector
E – LAN Connector Board
D ) on the LAN
A ) from the system board as
A ).
Disassembly and Reassembly 3-13