Using Hard Drive Security - NEC POWERMATE 2000 Service And Reference Manual

3. Click the
protocols are loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4. Highlight
warning window appears asking for confirmation to continue.
5. Click
Yes
NetBIOS lines disappear from the Configuration display.
6. Repeat steps 4 and 5 to remove the NetBEUI Protocol.
7. In the Configuration tab display, click
Add .
8. Highlight
window appears. If there is a DHCP server on the network, click
otherwise click
9. Change the path in the window to
window appears. If Yes was clicked in step 8, skip to step 16. If No was
clicked in step 8, the Windows Setup window appears.
10. Click
Close
11. Fill in the
"Specify an IP address" area.
12. Click the
13. Click the
14. Click the
15. Click the
16. Click
OK

Using Hard Drive Security

Your NEC PowerMate 2000 series system allows you to establish password
protection for the internal hard drive. Hard disk drive (HDD) password
protection restricts access to the drive only if the drive is removed from your
PowerMate 2000 series computer and installed in another system. The system
does not prompt you to enter your HDD passwords while the drive remains in
your current system.
The HDD passwords are written to the system BIOS and to the hard drive to
ensure that the password protection travels with the drive in the event it is
moved to another system.
A-8 PM 2000 Series Release Notes
tab. In the Configuration display, the following
Configuration
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink
and then
Microsoft TCP/IP
No .
. The Microsoft TCP/IP Properties Box appears.
IP Address , the Subnet
DNS tab and enter the host and domain name in the DNS display.
Identification tab and change the Computer Name if appropriate.
WINS tab and enter the WINS address if appropriate.
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
and click
Add . Highlight Protocol
and click . The TCP/IP Setup
OK
C:\I386 . Click Continue
Mask , and the Default Gateway
Yes
Remove . A
and click
Yes ;
. The Network
in the
.