Memory Module Installation Or Replacement - ESI -1000 Installation Manual

ESI Communications Servers Hardware Installation Manual

Memory Module installation or replacement

Note: The Memory Module has a proprietary formatting scheme — do not attempt to install a non-ESI drive.
Contact ESI for a replacement Memory Module, if needed.
Adding or replacing the Memory Module will require that the ESI-50 be taken out of service.
All of the ESI-50's configuration data and customer recordings are stored in the Memory Module. Replacing
it, therefore, requires re-programming and re-recording, unless you have previously performed a backup using ESI
System Programmer software. (Prompts stay intact, however.)
Note: Be sure to observe all proper procedures regarding the prevention of electrostatic discharge (ESD) when
performing the following procedures; otherwise, circuit boards may suffer damage.
Install the CompactFlash Memory Module
1. Open the lid of the cabinet (you must remove
the screw on the top that secures the lid).
2. Power down the system.
3. Plug the Memory Module into the J11 connector
on the main board (see diagram, right).
4. Secure the lid to the KSU.
Remove the CompactFlash
Memory Module (if replacing)
1. Open the lid of the cabinet (you must remove
the screw on the top that secures the lid).
2. Power down the system.
3. Remove the Memory Module from the J11 connector on the main board (see diagram, above).
4. To install the Memory Module, follow the steps in "Install the CompactFlash Memory Module," above.
H.5
ESI-50