Removing The Memory Module From The Main Board - ESI -1000 Installation Manual

ESI Communications Servers Hardware Installation Manual
Removing the Memory Module from
the main board
1. Follow steps 1–3 under "First, remove the
main board from the system . . ." (page F.5).
2. Remove the Memory Module cable connected to either J5
(ESI-200) or J6 (ESI-1000/ESI-600) at the rear of the
main board (Figs. MM-6 and MM-7, page F.7).
Note: On the ESI-1000, be sure also to remove the cable
for the secondary Memory Module from J7.
3. From the back of the main board (Fig. MM-8), remove the four
Philips screws securing the Memory Module standoffs.
Remove the Memory Module with the standoffs attached.
4. Remove the four standoffs from the Memory Module.
5. Follow the steps under "Next, install the Memory Module . . ."
(page F.5) and "Finally, reinstall the main board in the system . . ." (this page) to (a.) install a replacement
Memory Module onto the main board and then (b.) reinstall the main board in (and power-up) the system.
Fig. MM-8
F.8
ESI-1000, ESI-600, ESI-200