Work Flow Of The "Procedure For Setting Parameters From The Beginning - Omron 3G3RX-V1 Series Connection Manual

10．Appendix 2 Setting Procedure without the Configuration Files

10.2. Work Flow of the "Procedure for Setting Parameters from the Beginning"

The following is the procedure for making connection settings for remote I/O communications
of the DeviceNet using the "procedure for setting parameters from the beginning".
This section describes the detailed procedures for "10.3 Setting up the Controller without the
Configuration Files" and "10.4 Setting up the Network by CX-Integrator" (in red frames below)
to make settings with software without using "configuration files".
For details on the procedures for 7.3 Setting the Inverter, 7.4.1 Hardware Setting for the
DeviceNet Master Unit, and 7.6 Checking the Connection Status, refer to Section 7 because
they are the same as the "procedure for using the configuration files".
7.3 Setting Up the Inverter
↓
7.3.1. Hardware Setting
↓
7.3.2. Parameter Setting
↓
10.3. Setting Up the Controller Using
the Software
↓
7.4.1 Hardware Setting for the
DeviceNet Unit
↓
10.3.2. Starting the Sysmac Studio and
Setting Parameters for the
Controller
↓
10.3.3. Setting Global Variables
↓
10.3.4. Connecting Online and
Transferring the Project Data
↓
10.3.5. Settings in Watch Tab Page
↓
Set up the Inverter.
Mount the DeviceNet Communications Unit on the
Inverter.
Set the parameters for the Inverter.
Set up the Controller using the software.
Set the hardware switches on the DeviceNet Unit
and connect to the Controller.
Start the Sysmac Studio and set the parameters for
the Controller.
Set global variables used for the remote I/O
communications.
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
Make settings in the Watch Tab Page to check data
that are sent and received.
45