Cleaning The Air Filter; Replacing The Mist And Fluid Filters; Figure 4.1 Removing The Air Filter - Kodak Versamark DP7122 Operator's Manual

Hide thumbs Also See for Versamark DP7122:

Table of Contents

Figure 4.1

Removing the air filter

Cleaning the Air Filter

Remove and clean the air (vent) filter when it appears dirty. Air filter

0178610 is mounted on the back of the printer. Use the following

procedure to clean the filter:

1. Grasp the sides of the air filter and press down to free the top of the

air filter from the upper bracket; lift the air filter out of the bottom

bracket (Figure 4.1).

2. Rinse the air filter in tap water, shaking out the excess water.

3. Air dry or use compressed air to dry the air filter.

4. When the air filter is completely dry, seat the bottom edge of the filter

in the lower bracket and press down on the upper edge of the air filter

until it slips under the upper bracket.

The mist filter and the ink or replenisher filters may require changing if

system operating pressures rise. Changing these filters is a service

procedure. Contact your service technician or technical support at Kodak

Versamark, Inc.

Chapter 4. Maintenance

Periodic Maintenance

4 - 3

Table of Contents