Table of Contents
Advertisement
4 – Playback operations—ISRC view (drive 2 only)
Setting the pitch value (ii)
value from the remote control unit:
1
Press either of the
PITCH +
remote control unit when drive 1 is not in
menu mode.
ISRC view (drive 2 only)
On drive 2, the ISRC code (see "ISRC copy" on
page 15 for more information about this code), if
present on the disc, can be displayed during play-
RID view (drive 2 only)
The RID (recorder identification data)
can be shown for discs playing back on drive 2.
Press the
key while playback is taking place
ERASE
to display this data.
Auto Ready function
This function allows the playing back of a single
track, and the automatic cueing of the next track
ready for playback.
The unit is cued to the start of the track as determined
by the subcode, not the start of the audio signal,
unless the
function is on (see "Auto Cue
AUTO CUE
function" on page 26).
The unit will enter pause mode in the continue, shuf-
fle and programmed play modes, after the location
has taken place.
If repeat is active (see "Repeat playback" on
page 24), the unit will enter play ready mode at the
start of the next track (
REPEAT ALL
track which is being repeated (
Auto Cue function
The Auto Cue function allows you to set up the unit
so that when a track is selected for playback in pause
mode (cued), playback will start, not at the first posi-
tion of the track as indicated by the subcode, but at
the first position of the track where the audio level
exceeds a set trigger level.
The trigger level is set as follows:
26
TASCAM CD-RW402 Owner's Manual
To set the pitch
or
keys on the
–
1
, if present,
), or the start of the
).
REPEAT 1
NOTE
The pitch changes made in this way (or on the main
unit) do not take effect if the PITCH indicator is not lit.
back, if the
key is pressed while playback
FINALIZE
is taking place.
1. The first three digits of the RID are assigned
as the Manufacturer Code, the next four digits
as the Type Code, and the last five digits as the
Recorder Unique Number. TEAC's Manufac-
turer Code is "TCJ".
To set the function:
1
Press the appropriate
the
until the display shows
MULTI DIAL
. Push the
MENU
MULTI DIAL
2
Turn the
MULTI DIAL
. Push the
AUTO READY ?
3
Turn the
MULTI DIAL
shows
. Push the
A_READY>ON ?
Turning off the function is the same, except that
replaced by
.
OFF
When the function is on, the
tor is lit.
1
Press the appropriate
the
MULTI DIAL
until the display shows
. Push the
MULTI DIAL
MENU
2
Turn the
MULTI DIAL
. Push the
AUTO CUE ?
3
Turn the
MULTI DIAL
shows
A_CUE> xxxdB
key and turn
MENU
PLAY
.
until the display shows
.
MULTI DIAL
so that the display
.
MULTI DIAL
is
ON
display indica-
A-READY
key and turn
MENU
PLAY
.
until the display shows
.
MULTI DIAL
so that the display
.
Advertisement
Table of Contents
