10 - Specifications, Etc; Error Messages And Troubleshooting - Tascam CD-RW402 Owner's Manual

10 – Specifications, etc.
This section gives the specifications of the unit, as
well as information on error messages, etc.

Error messages and troubleshooting

The messages below do not indicate an error, but
are status messages which show the current
operations being performed on the appropriate
drive:
Message
Check Stop!!
COMPLETE
COPY Standby
ExtendChk
NOW COMPARE
Now Copy 1->2
NOW OPC
Now REPAIR
OPC Area CLR
PMA Writing
TOC Reading
Wait...
The following messages typically indicate an
error condition, or a condition which requires
attention:
Symptom
No sound on playback (the disc is playing and the time
display is incrementing)
No meter indication when a source is input
Copying is not possible (the copy keys do not work)
D-IN UNLOCK!
Cannot record on a disc (pressing
MONITOR)
PGM Full!
Disc Full! or Cannot Rec!
Disc Error
Erase Error!
The display suddenly shows PMA Writing
Rec Error
No OPC Area!
52
TASCAM CD-RW402 Owner's Manual
The extended recording check has ended
A finalize or erase operation is complete
Waiting to start a copy operation
Done when checking a disc for extended recording is taking place
A compare operation is taking place
Copying from drive 1 to drive 2 (shown on drive 1 only)
Checking the disc prior to a record operation
Shown when repairing a damaged disc
Aa CD-RW disc is full, the OPC area is being cleaned for further recording
Recording is stopped, and the disc is still being written
Shown when a disc is first loaded
The unit is in pre-copy or post-copy mode
The connections from the CD-RW402 to the amplifier system have not been
made properly, or the amplifier's input source selector is not at the correct posi-
tion.
Analog and/or digital volume ("Signal volume" on page 30) is set too low. The
signal is being input through an unselected input source ("Input selection" on
page 30).
Both drives must be stopped (not just in ready mode)
A digital input source has been selected, but the source is not connected or is
not switched on.
RECORD shows A finalized disc has been inserted. Use an unfinalized recordable disc.
An attempt has been made to create more than 100 program steps.
There is no space on the disc, or no tracks are available, or a general recording
error has occurred.
The disc is bad. If it is a CD-RW disc, you may refresh it (, "Refreshing a disc"),
otherwise replace the disc.
An error has occurred while trying to erase the disc.
Either the disc is full (this message will be prefaced by Disc Full!! ("Full disc" on
page 32) or an attempt has been mode to write more than 99 tracks.
General recording error. This may be caused by vibration or a shock during
recording, for example, or may be the result of a bad disc. Try recording again
with the same disc. If the message appears again, try a different disc.
Appears only with CD-R discs. The OPC area is full, and no further recording
is possible on this disc. Finalize the disc.
Meaning
Possible cause and remedy