Table of Contents
Advertisement
The options here are
,
,
,
–54dB
–48dB
–42dB
–36dB
4
Push the
MULTI DIAL
Incremental play
Incremental playback means that when the
is pressed (or if a STOP signal is received through
the
connector) while a track is being
CONTROL
played back, the playback position will be at the start
of the next track.
If the
key is pressed while the incremental
PLAY
playback mode is on, playback starts from the start of
the next track.
To set the incremental play mode on:
1
Press the appropriate
the
MULTI DIAL
until the display shows
. Push the
MULTI DIAL
MENU
EOM tally time
This allows the drive to send out an EOM (End of
Message) tally signal a set number of seconds after
the track has actually finished.
1
Press the appropriate
the
until the display shows
MULTI DIAL
. Push the
MENU
MULTI DIAL
2
Turn the
MULTI DIAL
. Push the
EOM TIME ?
TOC Editing (drive 1 only)
The concept of TOC editing may need a little expla-
nation. Although a finalized (non-recordable CD) has
its Table Of Contents (TOC) fixed, it is possible to
"fool" drive 1 into believing that the TOC is actually
different from the real disc's TOC.
This is done by editing the existing TOC and creating
a "virtual" TOC which is the table of contents for a
"virtual disc", that is, one which does not actually
exist.
It is possible, for instance, to combine tracks, to split
tracks into two, or to erase a track from the TOC. It is
also possible to redefine the start point and end point
of a track.
A disc whose virtual TOC differs from its physical
TOC can be recognized by the
flashing in the display.
4 – Playback operations—Incremental play
,
,
,
,
OFF
–72dB
–66dB
–60dB
,
and
.
–30dB
–24dB
.
key
STOP
MENU
key and turn
PLAY
.
key and turn
MENU
PLAY
.
until the display shows
.
MULTI DIAL
indicator
NO TOC
When the function is on, the
is lit.
2
Turn the
MULTI DIAL
. Push the
INC PLAY ?
3
Turn the
MULTI DIAL
shows
. Push the
IncPlay> ON ?
Turning off the function is the same, except that
replaced by
.
OFF
NOTE
Although there is no indication on the display when the
incremental play mode is selected, you will notice that
is in operation whenever you stop playback of a track.
3
Turn the
MULTI DIAL
shows
, where
EOM TIME> xs
and
. The
value indicates that no tally
0
99
0
signal is sent.
4
Push the
MULTI DIAL
See "CONTROL I/O" on page 51 for details of
pinouts, etc.
When the disc is played back, this virtual TOC is
used, and it may therefore be used when recording a
disc with a different TOC from that of the original.
The virtual TOC is lost when the drive tray is opened
or when power is turned off.
NOTE
The normal "Red Book" rules still apply. No more than
99 tracks may exist in the virtual TOC, and they must
each be at least four seconds in length.
In all these operations, remember that pressing STOP
is equivalent to answering "no" when you are asked
if an operation is to be performed.
All TOC editing operations except clearing the vir-
tual TOC must be performed in play ready (or play)
mode.
TASCAM CD-RW402 Owner's Manual
display indicator
A-CUE
until the display shows
.
MULTI DIAL
so that the display
.
MULTI DIAL
is
ON
so that the display
is a value between
x
.
27
Advertisement
Table of Contents
