Table of Contents
Advertisement
3 – Features and controls—Rear panel features
Rear panel features
k
l
Digital connections
These connections all han-
dle digital audio I/O.
k COAXIAL INPUT and OUTPUT
(DRIVE 2)
These RCA connectors accept and
transmit digital audio data to and from drive 2
respectively in SPDIF format.
The
connector accepts AES3-1992 (TYPE I) as
IN
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1 kHz.
l OPTICAL INPUT and OUTPUT
(DRIVE 2)
These TOSLINK-type optical connec-
tors accept and transmit digital audio data to and
from drive 2 respectively in SPDIF format.
The
connector accepts AES3-1992 (TYPE I) as
IN
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1 kHz.
m COAXIAL OUTPUT (DRIVE 1)
RCA connector outputs digital audio data from drive
1 in SPDIF format.
n OPTICAL OUTPUT (DRIVE 1)
TOSLINK-type optical connector outputs digital
audio data from drive 1 in SPDIF format.
Analog connections
dle analog audio I/O.
o UNBALANCED INPUT (2)
anced RCA connectors allow the input of –10 dBV
nominal level signals to drive 2 (red=right).
18
TASCAM CD-RW402 Owner's Manual
m n
o p q r
This
This
These connections all han-
These unbal-
s
t
v
w
p UNBALANCED OUTPUT (2)
unbalanced RCA connectors output the signal from
drive 2 at –10 dBV nominal levels (red=right).
q UNBALANCED COMMON OUT
connectors are used in the same way as the
setting for the headphone monitoring
COMMON
Drive 1 takes priority if both drives are playing, oth-
erwise the currently-playing drive takes priority
(red=right).
r UNBALANCED OUTPUT (1)
unbalanced RCA connectors output the signal from
drive 2 at –10 dBV nominal levels (red=right).
s BALANCED INPUT [L, R] (2)
anced XLR-type female connectors accept analog
signals at +4 dBu nominal levels to drive 2.
t BALANCED OUTPUT [L, R] (2)
balanced XLR-type male connectors output the ana-
log outputs from drive 2 at +4 dBu nominal levels.
u BALANCED OUTPUT [L, R] (1)
balanced XLR-type male connectors output the ana-
log outputs from drive 1at +4 dBu nominal levels.
NOTE
All XLR-type connectors are wired with 1=ground,
2=hot, and 3=cold.
Other connections
connections.
v CONTROL I/O
remote control and fader stop/start control of the
u
x
These
These
D
These
These bal-
These
These
These are control and power
This connector allows for
.
Advertisement
Table of Contents
