SWINGARM
3. Install:
Collar 1
●
To connecting rod 2.
NOTE:
Apply the molybdenum disulfide grease on the
collar and oil seal lips.
4. Install:
Connecting rod 1
●
Bolt (connecting rod) 2
●
Washer 3
●
Nut (connecting rod) 4
●
To relay arm 5.
NOTE:
Apply the molybdenum disulfide grease on the
bolt.
5. Install:
Relay arm 1
●
Bolt (relay arm) 2
●
Washer 3
●
Nut (relay arm) 4
●
To swingarm.
NOTE:
Apply the molybdenum disulfide grease on
●
the bolt.
Do not tighten the nut yet.
●
6. Install:
Swingarm 1
●
Pivot shaft 2
●
NOTE:
Apply the molybdenum disulfide grease on
●
the pivot shaft.
Insert the pivot shaft from right side.
●
7. Check:
Swingarm side play a
●
Free play exists → Replace thrust bear-
ing.
Swingarm up and down movement b
●
Unsmooth movement/binding/rough
spots → Grease or replace bearings,
bushings and collars.
5 - 55
CHAS
80 Nm (8.0 m · kg, 58 ft · lb)
85 Nm (8.5 m · kg, 61 ft · lb)