CAMSHAFTS
4. Measure:
Camshaft-to-cap clearance
●
Out of specification → Measure cam-
shaft outside diameter.
Camshaft-to-cap clearance:
0.020 ~ 0.054 mm
(0.0008 ~ 0.0021 in)
<Limit>: 0.08 mm (0.003 in)
Measurement steps:
Install the camshaft onto the cylinder
●
head.
Position a strip of Plastigauge
●
camshaft.
Install the clip, dowel pins and camshaft
●
caps.
Bolt (camshaft cap):
10 Nm (1.0 m • kg, 7.2 ft • lb)
NOTE:
Tighten the bolts (camshaft cap) in a criss-
●
cross pattern from innermost to outer
caps.
Do not turn the camshaft when measuring
●
clearance with the Plastigauge
Remove the camshaft caps and measure
●
the width of the Plastigauge
5. Measure:
Camshaft outside diameter a
●
Out of specification → Replace the
camshaft.
Within specification → Replace cam-
shaft case and camshaft caps as a set.
Camshaft outside diameter:
21.967 ~ 21.980 mm
(0.8648 ~ 0.8654 in)
Camshaft sprocket
1. Inspect:
Camshaft sprocket 1
●
Wear/damage → Replace the camshaft
assembly and timing chain as a set.
4 - 25
ENG
1 onto the
®
®
.
1.
®