Table of Contents
Advertisement
General troubleshooting
This section contains guidelines and testing procedures for resolving
basic operatioinal diffi culties and diagnosing mechanical, electri-
cal and electronic processes. Chapter 4 also contains related repair
procedures.
If the system isn't functioning correctly, fi rst determine which com-
ponent is causing the problem. Likely diffi culties may involve:
The computer
The power cord or communication cables
The apparel/marker design software
The FJ Printer
Changes to the computer operating system or the installation of new
peripherals or software can cause confl icts. If the problem appears to
be with the computer or apparel design software, consult the appro-
priate documentation or an Ioline dealer.
If the problem is with the printer, begin by making sure power is on and
that the cable between the machines and the PC is connected correctly.
The information in this chapter begins with the simplest and most
common issues, and progresses to more complex and invasive
troubleshooting. If you are unable to resolve a problem after consult-
ing this manual, fi ll out the Diagnostic Record at the beginning of
Chapter 4, then contact Ioline Customer Service.
Error messages
Error messages that are specifi c to the Ioline FJ Printer are divided
into two catagories: Control Center software errors and LED codes.
Software errors present themselves on the computer screen and usu-
ally indicate a communication problem. LED codes are visible on the
keypad and can be a green light, a red light or a combination of both.
The keypad LED code table (Figure 21) is helpful for isolating the
cause of obvious external or communication problems. Comprehen-
sive information later in the chapter can help troubleshoot mechani-
cal and electrical diffi culties. Errors caused by the operating system
or the plotting software should be resolved with the software author.
Chapter 3
Troubleshooting &
Testing
Advertisement
Table of Contents
Troubleshooting
