Figure 41. Bottom Cover Removal Steps; Left Bottom Cover Removal - Ioline FJ Printer Service Manual

70 Ioline FJ Printer & StudioJet Service Manual
Photo 1
Rear screw
Photo 4
Photo 7

Left Bottom Cover Removal

1. Power off and unplug the data and power cables.
2. Unplug the take-up motor cable from the bottom right side of
the machine (Figure 41, photos 1 & 2).
3. Remove the right and left screws on the rear of the machine
(Figure 41, photos 3 & 4). These hold the printer on the stand
(do not remove the front screws (Figure 41, photos 5 & 6).
4. Make sure the stop screws are installed on the take-up plate on
both sides of the machine (Figure 41, photos 5 & 6).
Photo 2
Front screw
Stop screw
Photo 5
Photo 8

Figure 41. Bottom cover removal steps.

Right rear
screw
Photo 3
Front screw
Stop screw
Photo 6
Philips screw
Photo 9