Ioline FJ Printer Service Manual page 46

46 Ioline FJ Printer & StudioJet Service Manual
No power when printer is turned on; Keypad lights stay dark.
Cause:
1. The power cord is damaged or
disconnected.
2. Check power supply voltage.
3. The printer is damaged and
needs professional service.
4. A fuse has blown.
5. Power supply failure.
Pauses during printing.
Cause:
1. Vector density is very high due
to fi ne detail or the design soft-
ware is not using fonts embed-
ded in the printer.
2. Communication baud rate is set
very low.
3. Frame length is too big.
Carriage refuses to move all the way to the right.
Cause:
1. Service Station failure.
Carriage hits the Service Station.
Cause:
1. Service Station spring is broken.
2. Service Station slider sticks.
Take-up motor will not stop turning.
Cause:
1. Paper sensor failed.
Solution:
1. Check the power connection.
2. See Repair Procedures later in
chapter 4.
3. Contact an Ioline distributor or
Ioline Customer Service.
4. Replace fuse.
5. Contact Ioline customer service.
Solution:
1. Reduce vector density, use em-
bedded printer fonts, or increase
communication baud rate.
2. Increase baud rate from the
minimum of 9600 baud to the
default of 38,400 or higher. Make
sure the FJ Printer and the soft-
ware are set to the same baud
rate.
3. Reduce frame length. Set be-
tween 5-in and 35-in.
Solution:
1. Contact Ioline Tech Support for
assistance.
Solution:
1. Contact Ioline customer service.
2. Contact Ioline customer service.
Solution:
1. Contact Ioline customer service.