Sony HKCU1001 Installation Manual page 18

Ref.No. Name
S407 TEST
S408 MODE2
1 NP-SEL AUTO/N
2
3 GRAY LINE/ON
4 MONI/SYNC
5
6
7
8 CO-AX DIS/ENB
S409 CCU-NO
1 to 4
5 to 8
S410 HD-SD DLY
S411 SEQ1&SEQ2
1-12 (E)
Function
Factory use
SD-Format setting
ON: Forced into NTSC (525).
OFF: For AUTO, follows the setting of 1.000 (=PAL) /1.001 (=NTSC).
Not used
Gray signal output setting
ON: During Gray signal output, when turning CB ON/OFF, the Gray image
disappears, leaving only the Line signal.
OFF: During Gray signal output, even when turning CB ON/OFF,
the Gray signal is output.
Does not function
Not used
Not used
Not used
Factory use
CCU No. setting
S409-4 to 1: 1' digit (BCD)
S409-8 to 5: 10' digit (BCD)
Video phase setting between HD and SD
Sets the phase difference (delay time) between HD signal and SD signal
output from CCU.
Can switch the delay settings among 0-DLY, LINE-DLY, and FRAME-DLY.
0-DLY : Same-phase mode of HD-SD (excluding 24PsF)
LINE-DLY : Sets the minimum delay amount of D/C. SD signal delays as
much as 90H (1080i) or 120H (720P).
FRAME-DLY : Sets the frame delay amount. SD signal delays as much as
1 frame (1080i) or 2 frames (720P).
* 90H is the level frequency of 1125-60i/50i, and 120H is that of 750-60P/50P.
Switch depending on the waveform monitor to be used.
+ : PNP : PNP open collector output
_ : NPN : NPN open collector output
Factory default setting
OFF
OFF
OFF
_
_
_
OFF
_
OFF (ALL)
OFF (ALL)
LINE-DLY
(+)
HDCU3300/IM (J.E)