InFocus IN5212a User Manual page 5

Power Safety
 Only use the supplied power cord.
 Do not place anything on the power cord. Place the power cord where it will not be in the way of
foot traffic.
 Remove the batteries from the remote control when storing or not in use for a prolonged period.
Replacing the Lamp
Replacing the lamp can be hazardous if done incorrectly. See
for clear and safe instructions for this procedure. Before replacing the lamp:
 Unplug the power cord.
 Allow the lamp to cool for about one hour.
Cleaning the Projector
 Unplug the power cord before cleaning. See
 Allow the lamp to cool for about one hour.
Regulatory Warnings
Before installing and using the projector, read the regulatory notices in the
on page 57.
Important Recycle Instructions:
Lamp(s) inside this product contain mercury. This product may contain other electronic waste that
can be hazardous if not disposed of properly. Recycle or dispose in accordance with local, state, or federal
laws. For more information, contact the Electronic Industries Alliance at www.eiae.org. For lamp specific
disposal information check www.lamprecycle.org.
Symbol Explanations
DISPOSAL: Do not use household or municipal waste collection services for
disposal of electrical and electronic equipment. EU countries require the use
of separate recycling collection services.
About this Manual
This manual is intended for end users and describes how to install and operate the DLP projector.
Wherever possible, relevant information—such as an illustration and its description—has been kept on
one page. This printer-friendly format is both for your convenience and to help save paper, thereby
protecting the environment. It is suggested that you only print sections that are relevant to your needs.
Replacing the Projection Lamp
Cleaning the Projector
— iv —
on page
on page 45.
Regulatory Compliance
41
section