Adjusting Fluidix Reflex, Nex, St, Intelli-Jets And Focus-Relief; Air Controls; Waterfall Control - Sundance Spas 880 Series Owner's Manual

880 Series
11.8 Adjusting Fluidix Reflex, Nex, ST, Intelli-Jets And Focus-
Relief
The jets in your new hot tub offer the advantage of no
moving parts and zero maintenance. They can also be adjust-
ed for a high and low impact massage, providing the ultimate
massage! To adjust jets:
1. Fluidix Nex/Intelli-Jets and Reflex Jets only: Turn outer
dial (A) clockwise to increase water volume. Turn outer
dial counterclockwise to decrease water volume or to shut
jet off.
2. Fluidix Intelli-Jet only: Rotate center "mode disk" (B)
clockwise to select a non-oscillating water stream or turn
counterclockwise to select an oscillating stream at any
angle.
3. For a high impact massage, turn corresponding air control
knob clockwise. For the Fluidix ST jet, this will create
a straight water flow. For low impact massage, turn
corresponding air control knob counterclockwise. For the
Fluidix ST jet, this will create an oscillating flow. Refer
to Sections 9.1-9.22 (pages 21-42) for specific
operation details. The included tool (shown) allows you to
position the jet nozzle angle to your liking. This tool can
also be used to aid in the opening or closing of the nozzle
on Fluidix Reflex jets.
4. Focus-Relief Jets: Work with both the blower and jets pump. The
blower introduces air to the jet and the jets pump forces water through.
Note: Always keep at least 6 adjustable jets open at all times on each
jet system.
11.9

Air Controls

Each jet system has its own air control. These controls allow
you to regulate the amount of air which is mixed with the water
entering through the jets. Clockwise rotation adds more air and counter-
clockwise rotation reduces air flow.
Note: To minimize heat loss, close all air controls when spa is not in
use. Certain jets may draw air even though they are closed. This is
considered normal.

11.10 Waterfall Control

Turn waterfall control valve counterclockwise to increase
waterfall(s) output. Turn control valve clockwise to decrease
or turn off waterfall(s) output. The waterfall is on when the
circulation pump is running.
Note: It takes 2 full revolutions to change the waterfall from a full off to
a full on flow rate. When the waterfall is in the OFF position some water
may still flow through. This is considered normal.
54
B
A
Fluidix Intelli-Jet
A
Fluidix Reflex Jet
Fluidix ST Jet
Focus-Relief Jet