Clutch, Primary Drive - KTM S5-E Repair Manual

3.7 Clutch, primary drive

– Remove all 7 screws and lift off the clutch cover and the gasket.
N : W -
OTE HEN REMOVING THE CLUTCH COVER KEEP IN MIND THE STOP DISK OF THE KICK
( ).
STARTER SHAFT CAN STICK TO THE INSIDE OF THE CLUTCH COVER
1
– Hold the clutch hub with the holding wrench and undo nut (LH thread).
– Remove nut and washer.
1
7
– Mount the extractor and pull off the clutch hub.
– Remove the clutch drum together with the two washers located behind it.
– Hold the primary gear with the holding wrench and undo the hexagon nut.
– Remove hexagon nut and washer.
– Mount the extractor and pull the primary gear off the countershaft.