Table of Contents
Advertisement
Printer Preparation
Line switch
Input power connector
Before starting the flush procedure, complete the following steps:
1. Read the "Safety Information" section.
Mandatory Action: Wear Eye Protection
Avoid contact with all fluids, ink and replenisher. Wearing goggles, gloves, and a
face shield is highly recommended.
2. Read the "Drain and Fill" procedure.
3. Perform a normal shutdown.
4. Power off the printer at the line switch (see Figure 2).
5. Unplug the input power cord from its connector.
Warning: Electrostatic Sensitive Devices
Do not disconnect the printer ground wire. If necessary, leave the power cord
plugged in to maintain an earth ground. The printer and waste container must
remain properly grounded at all times.
6. If you move the printer, check that all ground connections are
maintained and that all fluid containers have been properly
disconnected.
Figure 2
Line switch and input power connection, back panel
Safety and Preparation
Printer Preparation
5
Advertisement
Table of Contents
