Configured As A Standby Switch; Error Codes; Ws5100 Led Behavior; Start Up - Motorola WS5100 Series Migration Giude

5-2 WS5100 Series Switch Migration Guide

5.1.3 Configured as a Standby Switch

Active (acting as primary)
Monitoring
Standby not enabled
Inactive
NOTE: The Primary and Standby LED activity described above is unique to the WS5100
1.4.x and 2.x baselines. The primary and standby designations do not apply to the 3.0
version switch.

5.1.4 Error Codes

POST failed (critical error)
Software initialization failed
Country code not configured.
Note: During first time setup, the LEDs will
remain in this state until the country code is
configured.
No access ports have been adopted
Primary inactive or failed

5.2 WS5100 LED Behavior

The WS5100 version switch uses an LED scheme that takes advantage of the switch's failover capabilities
in addition to displaying LED events central to power up and error reporting. Refer to the following for LED
behavior unique to the 3.0 version WS5100 switch:

5.2.1 Start Up

Power off
Power On Self Test (POST) running
POST succeeded
Event
Event
Event
Top LED
Blue blinking
Blue blinking
Blue blinking
Amber blinking
Top LED
Red blinking
Amber solid
Amber solid
Blue blinking
Amber blinking
Top LED
Off
All colors in rotation
Blue solid
Bottom LED
Blue blinking
Amber solid
Off
Amber blinking
Bottom LED
Red blinking
Off
Amber blinking
Amber blinking
Blue blinking
Bottom LED
Off
All colors in rotation
Blue solid