Configure Pre-Shared Keys - Motorola WS5100 Series Migration Giude

3-22 WS5100 Series Switch Migration Guide
Diffie-Hellman Group Identifier
Navigate to the
follows:
1. Enter a Priority
2. Set the Encryption
3. Set the Hash
4. Set the Authentication
5. Set the SA Lifetime
6. Click OK to return to the
7. Click Apply

3.4.3.2 Configure Pre-Shared Keys

To configure pre-shared keys, specify the shared keys at each peer.
For this example we will only set up the pre-shared key for the one client that wishes to connect to the
remote network. In your network you will likely set up pre-shared keys for each of the clients using VPN.
NOTE: A given pre-shared key is shared between two peers. At a given peer you can
specify the same key to share with multiple remote peers; however, a more secure
approach is to specify different keys to share between different pairs of peers.
Navigate to the
1. Click the Add
2. In the Add Pre-shared Key dialog, choose
this case 157.235.188.4
3. Enter a Key
test12345 as the key.
768-bit Diffie-Hellman
1024-bit Diffie-Hellman
Security > IKE Settings >
value of 1.
to DES.
Value to MD5.
type to Pre-Shared Key.
to 10800 seconds (3 hours).
IKE Policy screen.
to save the new IKE Policy.
Security > IKE Settings >
button.
to be used as the pre-shared key for both client and server. For this example enter in
IKE Policy screen. For this example set those parameters as
Configuration screen.
Peer IP Address and enter in the IP address of the client. In
1 768-bit Diffie-Hellman
2
5
14
15
16
17
18