Installation Of Divider Plate - Dometic 57908.321 Installation Instructions Manual

Installing unit with 3105007.XXX or 3105935.XXX Re-
turn Air Cover, continued from page 13, column A.
6. Evenly tighten mounting bolts to compress gasket
to 1/2" this will be a torque of 40 - 50 inch pounds.
See FIG. 15A.
CAUTION
If bolts are left loose there may not be ad-
equate roof seal or if over tightened, damage
may occur to the air conditioner base or ceil-
ing template. Tighten to specifications listed
in this manual.
FIG. 15A
B. INSTALLATION OF DIVIDER PLATE
1. Measure the ceiling to roof thickness:
a. If distance is 2" - 3-3/4", remove perforated tab
from divider plate.
b. If distance is 3-3/4" - 5-1/2", remove no tabs.
2. Remove the backing paper from double sided tape
located on ceiling template. See FIG. 16A.
FIG. 16A
Installing unit with 3105007.XXX or 3105935.XXX Re-
turn Air Cover, continued on page 15, column A.
INSTALLATION INSTRUCTIONS DUCTED CCC
Installing unit with 3308120.XXX Genesis Air Filtration
System, continued from page 13, column B.
2. Install relay control box on ceiling template with
blunt self tapping screws depending on the model
used. See FIG. 16B for Brisk Air unit, and Fig. 17B
for Penguin units.
FIG. 16B
Brisk Air Models Mount
Control Box On Edge To
The Flange On Top Of
Ceiling Template
Vehicle
Front
FIG. 17B
Penguin Models Lay
Control Box Flat On Top
Of Ceiling Template
Vehicle
Front
3. Start each mounting bolt through the ceiling tem-
plate and up into the unit base pan by hand. Evenly
tighten mounting bolts to compress gasket to
1/2" this will be a torque of 40 - 50 inch pounds.
If bolts are left loose there may not be ad-
equate roof seal or if over tightened, damage
may occur to the air conditioner/heat pump
base or ceiling template. Tighten to specifi-
cations listed in this manual.
Installing unit with 3308120.XXX Genesis Air Filtration
System, continued on page 15, column B.
14
Control Box
Three
Screws
Control Box
Two
Screws
CAUTION