Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
FIG. 27
Attaching Housing Assembly To Strain
Relief Cover With Tongue And Groove
Pliers, Squeeze Squarely & firmly
Between Ribs A & B
Strain Relief Cover
Locking
Latch
Rib B
Locking
Rib A
Ramp
10. Inspect the connector to ensure the wires have
been properly engaged into the housing assem-
bly contacts. A properly terminated wire is fully
seated into its proper slots with no significant
bow of the cover. If the wires extend past the
insulation stops the wires must be re-terminated
with a NEW CONNECTOR. Once the cover has
been closed the connector cannot be re-used.
Failure to comply with this procedure may result
in the failure of the connector.
11. Mating and un-mating the completed connector
is illustrated below. See (FIG. 28).
FIG. 28
Housing
Depress Mating Latch
Assembly
To Disconnect
Depress Mating
Strain Relief
Cover
Latch To Disconnect
"Hermaphroditic" Part Mates With Itself
To release the connector system, depress both mating
latches at the same time and pull the connectors apart.
To reconnect, simply re-mate the connectors and slide
them together until mating latches lock.
10" Minimum
Housing Assembly
Strain Relief
Cover
Housing
Assembly
J.
Duct Divider Installation
1. M easure the ceiling thickness. See (FIG. 17).
2. Cut away the number of rows as indicated in
table below. See (FIG. 29).
Ceiling
Thickness
Min.
Max.
6.0
6.5
5.5
6.0
5.0
5.5
4.5
5.0
4.0
4.5
FIG. 29
Remove Rows
Starting Here
3. Carefully install the duct divider in the roof
opening 5-5/8" from back of roof opening. See
(FIG. 30).
Foil back faces rear of unit.
FIG. 30
Duct Divider
5-5/8" From Back
Of Roof Opening
K.
LCD SZ System Low Voltage Wire
Connections
Verify the positive (+) 12 Vdc termi-
nal is disconnected from supply battery. Otherwise,
damage to unit could occur.
1. P lastic Case Electronic Control Kit Systems
Only
a. Plug the supplied freeze control sensor and
the 4 wire harness into their matching con-
nectors in the electronic control box.
14
# Of
Ceiling
Rows
Thickness
To Cut
Min
Max.
0
3.5
4.0
1
3.0
3.5
2
2.5
3.0
3
2.0
2.5
4
1.5
2.0
Base Pan
Front
Black Side
Rear
To Front
# Of
Rows
To Cut
5
6
7
8
9
Hide quick links:
Advertisement
Table of Contents
