Show Ipx Network <Network_Name> Settings; Show Ipx Rip - 3Com OfficeConnect Remote 812 Cli User's Manual

B-44 A B: CLI COMMAND DESCRIPTION
PPENDIX
show ipx network
<network_name>
settings

show ipx rip

Displays parameter settings for the specified IPX network. You can modify most of
these values using the set ipx network command.
Interface - interface this IPX network uses


Network Address - network address of this IPX network


Frame Type - frame type used by the interface (ETHERNET II, SNAP, or


LOOPBACK)
Maximum Packet Size - maximum allowable packet size for this IPX


network. Default is 1500.
Status - operational state of the network


Network Delay (ticks) - time in number of ticks it takes to reach this IPX


network
Network Learning Retries - number of times this network will resend


packets to discover its directly connected neighbors
Diagnostics - sending of diagnostic packets ENABLED or DISABLED


NetBIOS - support ENABLED or DISABLED


NetBIOS Name Caching - support ENABLED or DISABLED


NetBIOS Cache Timer (sec) - interval a NetBIOS system will be kept in the


cache
NetBIOS Maximum Hops - most hops this network will make to locate a


NetBIOS system
RIP - RIP status


RIP Update (sec) - number of seconds to wait before aging out RIP entries


RIP Age Multiplier - number to multiply the rip_update_interval by, to


obtain the value for aging out the entries in the RIP database
RIP Max Packet Size - largest allowable size of a RIP packet


SAP - SAP state


SAP Update (sec) - number of seconds to wait before aging out SAP


entries
SAP Age Multiplier - number to multiply the sap_update_interval by, to


obtain the value for the aging out entries in the SAP database
SAP Packet Size - greatest allowable size of a SAP packet


SAP Nearest Server Reply - SAP seeks nearest neighbors, YES or NO


settings


counters


Displays information about RIP for IPX.
Parameters Description
settings Displays the state of the IPX routing. This is ON or OFF.
counters Displays the Incorrect RIP Packets for the IPX routing. The incorrect RIP
packets are the number of RIP packets that do not make sense.