Show Command; Show Configuration; Show Critical_Event Settings; Show Date - 3Com OfficeConnect Remote 812 Cli User's Manual

show command

show configuration

show critical_event
settings

show date

show dhcp relay

Last Clearing reason: indicates why the call was cleared. Reasons for clearing


include, line down, PPP timeout, Authentication error, Network configuration
error, and termination initiated from the local and remote side.
IP, IPX, and Bridge status: current status of each network layer.


Configured - protocol is configured for this VC and the call is being


initiated
Not configured - The protocol is disabled on this VC.


Established - Protocol was negoitated successfully and is currently active


on this VC.
Failure - Protocol was configured, but there was a failure in the PPP


negotiation while attempting to initiate the network layer.
Displays the settings for Command History Depth, and the Current Prompt. You
can modify the history depth using set command history, and alter the prompt
using set command prompt. Prompts can hold a maximum of 64 characters. For
example:
History Depth: 10
Current Prompt: OCR-DSL>
Local Prompt: OCR-DSL>
Displays a variety of system information including: System Identification,
Authentication Remote, Remote Accounting, Interfaces, IP forwarding, IPX Default
Gateway, Bridge Spanning Tree, and DNS Domain.
Displays where the log files for critical event messages are stored in the FLASH file
system.
Critical Event Sink - where critical events are logged, default is


@file:/./log-file.local
Critical Event Backup - where critical events are logged, if the first


destination fails, default is @file:/./old-log-file.local
Displays the system date, time, and uptime. For example:
System Date:
System UpTime:
Displays the current configuration and counters for both the primary and
secondary DHCP relay server.
IP Address - IP address of the DHCP Server.


Max Hops - maximum hops to get to this server.


Status - enabled or disabled.


Request Sent to Server - number of requests sent to server.


09-FEB-2107 15:06:10
2d 08:37:54
CLI Commands B-37