Set Ipx Network <Network_Name> - 3Com OfficeConnect Remote 812 Cli User's Manual

B-28 A B: CLI COMMAND DESCRIPTION
PPENDIX
set ipx network
<network_name>
metric_maximum_entries
rip_flags
Router_id
delay_ticks [number]


diagnostics [DISABLE | ENABLE]


maximum_learning_retries [number]


netbios [ENABLE | DISABLE]


netbios_name_cache [DISABLE | ENABLE]


netbios_cache_timer [seconds]


netbios_max_hops [number]


packet_maximum_size [number]


rip [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]


rip_age_multiplier [number]


rip_packet_size [number]


rip_update_interval [number]


sap [BOTH | DISABLE | LISTEN | RESPOND_ONLY | SEND]


sap_age_multiplier [number]


sap_packet_size [number]


sap_nearest_replies [ON | OFF]


sap_update_interval [number]


Sets parameters for the specified IPX network.
Parameters Description
<network_name> Designation of the IPX network. Maximum size is 32 characters.
delay_ticks Interval in number of ticks it takes to reach this IPX network.
diagnostics Whether or not to send diagnostic packets to this IPX network.
maximum_learning_ Number of times this network will resend packets to learn its directly
connected neighbors.
retries
netbios Whether to support NetBIOS on dial-out IPX networks.
netbios_name_cache Whether or not to cache a list of the other NetBIOS systems on this
IPX network.
netbios_cache_timer How long a NetBIOS system will be kept in the cache.
netbios_max_hops Maximum number of hops this network will make to locate a
NetBIOS system.
packet_maximum_size Maximum size packet that this IPX network will support.
rip Sets the RIP mode.
Most next hop entries the system table can maintain.
Flags indicate at which level a RIP instance is disabled or
configured. Choices are:
METRICS - Specifies how to increment metrics using
RFC1058.
SEND_REQUEST - Sends a RIP request for routing information
when an interface first comes up.
The IP station address of the ip router.