Installing Batteries; Using The Ac Adapter - HoMedics BPA-110 User Manual

INSTALLING BATTERIES

1. Press down on latch and lift the battery cover to open the
battery compartment.
2. Install or replace 4 "AA " sized alkaline batteries in the
battery compartment according to the indications inside
the compartment.
3. Close the battery cover by pushing in the top end of the
battery door.
Replace the batteries if:
• The weak battery symbol appears on the display.
• Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be
discharged earlier than batteries you buy in stores. Replace
all batteries at one time (as simultaneous set). Use only 1.5V
"AA" alkaline batteries. Remove batteries when unit is not in
use for extended periods of time. Date and time will need to
be reset if batteries are removed or replaced. Clean contacts
on battery and in battery compartment with a soft dry cloth
each time you install batteries.
Note:
Batteries are hazardous waste. Do not dispose of them
together with the household garbage.
Battery
Cover
11

USING THE AC ADAPTER

1. Connect the AC adapter with the AC adapter jack in the
back of the unit as shown below.
2. Please use only the AC adapter included with this
monitor.
Note:
• When the AC adapter is your main power supply, make
sure the adapter plug can be easily removed from the
unit.
• Please unload the batteries when operating with an AC
adapter for an extended period of time. Leaving the
batteries in the compartment for a long time may cause
leakage, which may lead to damage to the unit.
• No batteries are needed when operating with an AC
adapter.
• Date and time will need to be reset if AC adapter is
unplugged and unit is without batteries.
Connect AC
adapter here
AC Adapter
Input: 100-240V~0.18A 50/60Hz
Output: 6V DC 1A 6W Max
12