Installing Batteries - HoMedics Walgreens WGNBPW-910 Manual

INSTALLING BATTERIES

1. The battery cover is located along the
side of the monitor. Remove battery
cover by pressing down and pulling
away from the monitor.
2. Install batteries according to the
polarity indications inside the
compartment (as shown in Fig. 2).
Battery Type: 2 Alkaline (LR03)
"AAA" size.
3. Insert the other battery, according
to the polarity indications inside the
compartment (as shown in Fig. 3).
4. Replace the cover by inserting it
back into place.
1.
2.
3.
4.
11
Replace the batteries if:
• The weak battery symbol appears on the display.
• Nothing appears on the display when the power is
switched on.
Note:
• Date and time will need to be reset if batteries are
removed or replaced.
• Replace all batteries at one time (as simultaneous
set). Use only 1.5V "AAA" alkaline batteries.
• When the batteries are removed, the measurement
values stored in memory are retained. However, the
date and time must be re-set.
• Remove batteries when unit is not in use for extended
periods of time.
• Clean contacts on battery and in battery
compartment with a soft dry cloth each time you
install batteries.
• Batteries are hazardous waste. Do not dispose of
them together with the household garbage.
12