Releasing The Drive Latch - IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual

3. Determine the bay into which you want to install the drive.
4. Install the drive CRU:
Figure 89. Releasing the drive latch
5. Check the drive LEDs.
6. Use the Storage Manager client to configure the drive.
7. Update the information in Appendix A, "Records," on page 155.
122
IBM TotalStorage DS4300 Fibre Channel Storage Subsystem: Installation, User's, and Maintenance Guide
Note: The hard disk drive comes with a tray already attached. Do not attempt
to detach the drive 4 from the tray 3 . See Figure 89.
a. Release the blue latch 1 on the drive CRU by pressing on the inside of
the bottom of the tray handle. See Figure 89.
b. Pull the handle 2 on the tray out into the open position.
c. Slide the drive CRU into the empty bay until the tray handle 2 touches the
storage-server bezel.
d. Push the tray handle 2 down into the closed (latched) position.
a. When a drive is ready for use, the green Activity LED is either continuously
on or rapidly flashing, and the amber Drive fault LED is off.
b. If the amber Drive fault LED is completely on and not flashing, remove the
drive from the unit and wait 10 seconds; then reinstall the drive.