Panasonic BT-LH910G Operating Instructions Manual page 43

Main Menu
(continued)
■
"WFM/VECTOR"
The "WFM/VECTOR" function enables display of the waveform and vector display. Use "DISPLAY
SETUP" in the main menu to select "WFM" and "VECTOR" display. (page 50)
Press the button ([FUNCTION1] to [FUNCTION3] (page 39)) to which the "WFM/VECTOR" function has
been assigned to switch the display in the following order.
WFM/VECTOR OFF → WFM Y ON → WFM R ON → WFM G ON → WFM B ON → VECTOR (x1 to x8)
• This assumes that the "WFM/VECTOR" function has been assigned to any of the [FUNCTION1] to
[FUNCTION3] buttons.
WFM is displayed in the order of the Y signal, R signal, G signal, and B signal.
Normal screen
* 1
Displayed only for SDI signal input.
• The scale display is as shown below.
100 %
50 %
0 %
Press the FUNCTION button to which the WFM/VECTOR function has been assigned.
Press the
button again
WFM display
(Y→R→G→B)
Press the
button again
WFM
(waveform display)
These examples show 16:9 aspect ratio images.
This dotted line is 109%.
A dotted line indicates for
each 10% increase.
This dotted line is -4%.
I axis
The frame is ±2.5°, ±2.5 %
Q axis
*
VECTOR display 1
VECTOR
(vector display)
43