Panasonic BT-LH910G Operating Instructions Manual page 35

Main Menu
(continued)
Sub menu
COLOR SPACE *
5
POWER SAVE
MODE
CALIBRATION
AREA SETTING
* 5
The factory preset setting value varies depending on the area set in "AREA SETTING".
*
6
ITU-709 indicates the ITU-R BT.709 standard.
■
CALIBRATION
The CALIBRATION function in this unit measures LCD panel characteristics from low to high brightness
values and internal monitor processing handles CALIBRATION.
CALIBRATION does not rely on image quality settings since internal signals are used for a calibration.
CALIBRATION in this unit is made at D65 color temperature and other color temperatures are results
calculated automatically from this value.
■
Equipment required for calibration
• Konica Minolta CA-210
or CA-310 display color
analyzer
• Konica Minolta CA-
PU12 or CA-PU15
standard measurement probe
• A RS-232C cable (male to male, straight)
Connect the SERIAL terminal on this unit to the RS-
232C terminal on the display color analyzer using a
straight cable.
Settings Description
SMPTE-C Sets the studio standard color space.
EBU
*
ITU-709 6
OFF Sets the power save mode
ON <ON> The backlight dims when no signal (NO SIGNAL) is input
▼ Connect Display Color Analyzer CA-210 and then perform
calibration. This also allows you to restore the calibration data to
the factory preset setting values.
(pages 35, 36, and 37)
NTSC Selects the area of the unit.
NTSC (J) (→ "Selecting Area of Use" on page 8)
PAL • The setting does not vary depending on the operation of SETUP
LOAD or POWER ON SETUP.
SERIAL Terminal (9P)
for 60 seconds or longer. Signal input or menu operation
will return the backlight to its normal brightness.
Analyzer Side
Pin number Signal
1
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 GND
(Straight) This unit Side
Pin number Signal
CD 1
2
3
4
5
6
7
8
9
(Continued on next page)
N.C.
TXD
RXD
DSR
GND
DTR
CTS
RTS
N.C.
35