How to Remove the Tilt Stand
When you do not want to use the tilt stand such as when using the unit as a VF (viewfinder), remove the tilt
stand mounting screw (four screws) with a Phillips driver and then remove the tilt stand from the unit.
When attaching the tilt stand, make
sure to align the protrusions for
alignment with the corresponding
alignment holes.
<Notes>
•
When tilting the monitor, be careful not to trap a hand between the monitor and stand.
•
When not using the tilt stand, take care that the unit does not fall over.
•
When the unit will be permanently installed in one place, we recommend securing it in place using the
screw holes at the bottom of the stand.
Alignment hole
17