System Option Setting - TEC MA-1350-1 Series Programming Manual

System Option Setting

This operation is provided for your selections of the register's basic functions according to the market and
your requirements.
Programming Procedure
The System Options are divided into 22 addresses (Addresses 1 to 23; Address 10 is vacant) and each
address is further divided into a maximum of 8 bits (Bits 1 to 8). Each address table is placed on the following
pages.
Condition: After Daily Financial Reset
Programming Procedure:
Use the MA Key to turn the Control Lock to "SET" or the S Key to turn the Control Lock to "BLIND".
MGR
X
REG
OFF
SET
MGR
X
REG
OFF
SET
(BLIND)
ST
Address No. (max. 2
digits; 1 to 23)
Enter a maximum of eight-digit number composed of Bit Nos. whose status must be set to the "SET" status
in the Address. If there is no Bit Nos. to be set to the "SET" status, enter "0" for the Address.
Examples) To set Bit 2 only .............................. Enter 2.
To set Bits 2 and 3 ......................... Enter 23.
To set all the Bits ............................ Enter 12345678.
To reset all the Bits ......................... Enter 0.
To change any Bit in an address, enter the Address No. and enter all the SET Bit Nos. again. If a Bit No.
is not included in the SET Bit Nos., the Bit will be RESET.
To access Addresses 1 to 13:
-
Z
To access Addresses 1 to 17:
To access all Addresses 1 to 23:
-
Z
Repeat for Bit status changes in all the required Addresses.
Bit Nos. that are set to "SET" status
(max. 8 Bit Nos. combination of 1 to 8)
- 23 -
MA-1350-1 SERIES
1 1
1 8
1 8
#/NS
(
or #/CID ,
EO3-11084
@/FOR
AT/TL
)
#