Toshiba RAV-SM1603AT-E Service Manual page 138

4. How to replace the parts (Continued)
No. Work procedure
Remove the reinforcing plate.
7
Note)
• The reinforcing plate is provided to protect
the transportation. Scrap it after unpacking
because it is unnecessary to attach when
reassembling.
Take off the screws which fix the bell mouth at the rear side of the motor and also take off the screws of
8
the motor mounting plate of the mounted fan motor.
Pull the motor mounting plate toward you while pushing it to the frame.
Be careful not to drop it.
Together with the removed bell mouth, slide
9
the motor mounting plate under fan motor
mounting status toward you and then take it
out from the main unit.
Note)
• Take out the motor mounting plate by
sliding it while pushing it to the frame side
so that the motor mounting plate is not
dropped from the frame.
5. Assembling work after replacing fan motor
• After replacing of the parts, assemble the fan motor in the reverse procedure of the parts removal process.
• Mount the removed Silocco fan at the following position as shown in the figure.
15
Removed Silocco fan (Front side)
Bell mouth
Detailed drawing of Silocco fan mounting position
– 138 –
Explanatory drawing
Frame
Motor mounting plate
Bell mouth
Motor mounting plate
Reinforcing plate