Toshiba RAV-SM1603AT-E Service Manual page 145

No. Part name
1. Detachment
9 Reactor
assembly
1) Carry out works of 1 of 1 , 3 and 4 .
2) Remove lead wires connected to the terminal block.
3) Cut the bundling band which binds the rector lead
4) Remove screws of the rector assembly.
5) Lift up the reactor assembly and then remove it from
The reactor assembly has heavy weight (9kg);
be careful for handling it.
6) Remove the reactor cover. (ST1T Ø4 × 10, 6 pcs.)
Note)
The lead wires pass through the square hole of the rector
cover. Therefore pay attention so that lead wires are not
damaged by edge when they are pulled out.
7) Remove the reactor. (ST1T Ø4 × 10, 4 pcs.)
1. Assembly
1) Assemble the reactor with procedure 7) to 1).
Arrange the reactor as same as that which is replaced.
Procedure
wires.
(ST1T Ø4 × 8, 7 pcs.)
the main unit.
X CAUTIONX
XREQUIREMENTX
Service reactor Marking
N side No
L side Yes
– 145 –
Remarks
Bundling band Bundling band Bundling band
Reactor lead Reactor lead Reactor lead
Screws Screws Screws
Reactor cover (A) Reactor cover (A) Reactor cover (A)
Screws Screws Screws
(at opposite side, also) (at opposite side, also) (at opposite side, also)
Marking (Red) Marking (Red) Marking (Red)
N side (Upper side) N side (Upper side) N side (Upper side)
No marking No marking No marking
L side (Lower side) L side (Lower side) L side (Lower side)
Marking Marking Marking