Toshiba RAV-SM1603AT-E Service Manual page 143

No. Part name
1. Detachment
7 Replacement
of electric parts
1) Carry out works of 1 of 1 , 3 and 4 .
Electrolytic
2) Remove the lead wire connected to the terminal block.
condenser
3) Remove the connector connected to the noise filter.
4) Remove the lead wire connected to the noise filter.
5) Cut the bundling band which binds the upper lead of
6) Remove the fixing screws for the electric parts box (A).
7) Remove the noise filter.
8) Remove the lead wires connected to the electrolytic
9) Remove screw of the condenser mounting band.
10) Remove the electrolytic condenser.
11) Mount a new electrolytic condenser.
Procedure
(IPDU crossover wire)
(IPDU crossover wire)
(Fuse crossover wire, power supply crossover wire)
the fan motor/lead of reactor.
(BT2T Ø4 × 6, 7 pcs.)
condenser. (Hexagonal bolt Ø5 × 12, 2 pcs.)
(BT2T Ø4 × 6, 1 pc.)
– 143 –
Remarks
Electric parts box (A) Terminal block
IPDU IPDU IPDU
crossover wire crossover wire crossover wire
Fuse Power supply
crossover wire crossover wire
Bundling band
Condenser Condenser Condenser
mounting band mounting band mounting band
Hexagonal bolt Hexagonal bolt Hexagonal bolt