Toshiba RAV-SM1603AT-E Service Manual page 149

No. Part name
1. Detachment
PMV coil
12
1) Carry out work of item 1 of 1 .
2) Turn the coil while pulling upward and then
2. Attachment
1) Surely match the positioning projection of the
Fan guard 1. Detachment
13
1) Carry out works of item 1 of 1 and work of 2 .
To prevent scratch on the product, carry out the
work on cardboard, cloth, etc.
2) Remove the discharge port cabinet and then
3) Remove the hooking claws (8 positions) of the
2. Attachment
1) Push the hooking claws (8 positions) with
Check that all the hooking claws are fixed at the
specified positions.
Wiring process 1. Sensor lead, compressor case thermo lead, PMV
14
lead
(Final check)
1) Turn the remained length of lead, bind it and
2) Fix the lead with bundling band so that it does
2. Fan motor lower lead, 4-way valve lead
1) Fix them to terminal block fixing plate with
Procedure
remove the coil from the PMV main unit.
coil with the concave part of PMV main unit
and then fix it.
XREQUIREMENTX
put on it so that the fan guard side directs
downward.
fan guard.
hands from the front side to fix the claws.
XREQUIREMENTX
then fix with bundling band.
not come to contact with earth screw.
bundling band. (Bind with crossed right-up)
Positioning projection
Fan guard
Terminal block Terminal block Terminal block
mounting plate mounting plate mounting plate
Bundling band Bundling band Bundling band
Terminal block Terminal block Terminal block
fixing plate fixing plate fixing plate
– 149 –
Remarks
Concave part PMV main unit
PMV coil
Bell mouth Discharge
port cabinet
Hooking claw
Earth screw Earth screw Earth screw
Bundling band Bundling band Bundling band Bundling band (Forming) Bundling band (Forming) Bundling band (Forming)
∗ 1 piece: at rear side ∗ 1 piece: at rear side
(Binding) (Binding) (Binding) 1 piece: at rear side
Fan motor Fan motor Fan motor
lower lead lower lead lower lead
4-way valve lead 4-way valve lead 4-way valve lead